• This thread M10 x 1.25 is used on all SINCO manifold turbo flanges

• Used to replace your factory exhaust manifold studs & turbo manifold studs

• Overall length = 40mm

• Suits RB 2JZ 1JZ SR20 CA18 4G63 and more

These turbo studs are ideal for fitting any turbo to manifold or to replace the exhaust manifold studs in your head.

Do I use turbo manifold studs or bolts??

We recommended using studs instead of bolts for x2 main reasons:

If you are using bolts over time the more you pull your turbo off and on the more you will wear out the threads in your turbo flange (this thread is alot harder to repair when stripped than replacing a stud). When studs are fitted to your turbo flange you will remove a nut from the stud and this can easily be replaced once worn out.

The second reason is a m10 locknut has a 14mm head size and a m8 locknut has only a 12mm head size, this means you will have alot more clearance around the turbo housing when tightening the locknut. For a bolt the head size is 13mm for m8 or 16mm sometimes 17mm for the m10.